All You Need to Know About the Best Decorative Concrete
Stamped concrete can be a beautiful addition to any property. However, if it is poorly done, it will turn out badly for you and the contractor as well. It is important that there are no spots that are missed while stamping and the contractors do not realize this until the slab is washed before the final sealing. These scenarios have been experienced by the best contractors and they know how to prevent them and this is why you should only consider the experienced contractors. There are several tricks that will help achieve better texture and they are listed below. It is important to make sure that you stamp as early as possible. You do not need a tamper as you will need to just walk on the stamps into the surface if you start stamping early.
You can also use retarders when stamping so that you reduce the rate of evaporation. It is possible to assume that the slab has already become hard enough just because you can see that it has crusted. However, once you start stamping on the surface, you will realize that you are sinking because the crust is cracking. So that you keep the top from drying prematurely, you will need to apply evaporation retarder. The evaporation is going to be slowed down when you apply the retarder and the texture on the slab will be excellent.
The slab needs to be crawled as the next step. Just before you start with the stamping, you will need to send people out on kneeboards. The weight and the vigorous floating of the slab will work the surface up. You will get the same consistency throughout the slab and this will enable stamping be easier. You will easily get the results you want this way. You can always save the situation by rolling the surface especially if the slab starts to get ahead of you. Getting texture is easier this way.
One of the best ways if stamping is using textured shoes and they are one of the greatest tools. Do not expect any straps or buckles on stamping shoes and they use friction to be held in place. Once you wear these shoes, you will have the weight spreading over a wide area and you do not have to fear that you will sink. It is always advisable that you start in the middle of the slab going out. Stamping will be more uniform this way and you will not have the problem of different textures on opposite ends of the slab. The only thing you will need to note about this technique is that you will need to have more stamps than normal so that you get the consistency you are looking for.